How to create a CruiseControl RAID config using existing parity data

This scenario is valid only if:
- You have not re-installed your OS
- You don’t have a copy of your configuration database
- The copy of your configuration that is on your PPU is somehow missing

Otherwise, please follow this guide instead (minus the restore section): http://wiki.flexraid.com/2012/03/24/how-do-i-restore-if-i-lose-both-my-os-drive-and-a-data-drive-and-dont-have-backups-of-my-raid-config/
This guide is also helpful: http://wiki.flexraid.com/2012/03/25/how-do-i-add-my-drive-back-to-the-pool-after-re-installing-my-os/

To create a new CruiseControl Snapshot or Real-Time RAID configuration using existing parity data, follow the steps below;

1. Create a new CruiseControl configuration into which you will be adding your existing drives with data

 

2. Add your drives to the configuration through the drive manager in the order they used to be

 

3. Initialize the RAID choosing to use the existing parity data when prompted

 

4. Check the configuration by running Quick-Validate or any other task

Be Sociable, Share!

Revisions

No comments yet.

Leave a Reply

19 − ten =